|
|
IInstallation Instructions | Product Maintenance & Important Info | Product Service Info | Download Owners Manual
2. To begin installation attach the SpecOps Folder to the shotgun, align pistol grip with the rear of the shotgun receiver. Insert ball end allen wrench into the hole located on the bottom of the SpecOps Folder (Fig. 2 & 3) and firmly tighten the pre-installed Hex head bolt and washers. During installation, make sure that the stock is properly aligned and square with the receiver. Be careful not to strip or cross thread mounting bolt or receiver nut.
 
Note: For Winchester SpecOps Folder, there should not be a gap between stock and shotgun after installation. Continue to tighten bolt until gap is closed.
Note: For Mossberg SpecOps Folder only, remove rubber o-ring from stock bolt. Remove o-ring by inserting ball end allen wrench into hole located on the bottom of the SpecOps Folder. Turn wrench counter clockwise while applying pressure to the bolt with finger. Turn wrench untill rubber o-ring is removed.
|
|
|
|
|
