IInstallation Instructions | Product Maintenance & Important Info | Product Service Info | Download Owners Manual
SpecOps Stock Installation Instructions Continued
1. Remove original stock. Refer to manufacturer’s instructions for the best method to remove stock. Normally the pad is held in place by two Phillips screws and the stock is held on by one bolt. Remove the pad by unscrewing the Phillips screws and remove the stock bolt to free the stock from the shotgun. (Fig. 1) Remington owners: Remove any metal spacers from the back of the receiver.
2. Prepare SpecOps Stock for installation by removing rear butt stock from SpecOps Stock. To remove pull down on lever assembly and slide off buttstock. (Fig. 2)
Note: For Mossberg SpecOps only, remove rubber o-ring from stock bolt. Remove o-ring by inserting ball end allen wrench into hole located on the bottom of the SpecOps Stock. Turn wrench counter clockwise while applying pressure to the bolt with finger. Turn wrench untill rubber o-ring is removed.
3. To begin installation attach the SpecOps Stock to the shotgun by aligning pistol grip with the rear of the shotgun receiver. Insert ball end allen wrench into the hole located on the bottom of the SpecOps Stock (Fig. 3) and firmly tighten the pre-installed Hex head bolt and washers. Make sure that the stock is properly aligned and square with the receiver. Be careful not to strip or cross thread mounting bolt or receiver nut.
 
Note: For Winchester SpecOps, there should not be a gap between stock and shotgun after installation. Continue to tighten bolt until gap is closed.
|
