|
|
IInstallation Instructions | Product Maintenance & Important Info | Product Service Info
Step 1: Remove original stock. Refer to manufacturer’s instructions for the best method to remove stock. Normally the pad is held in place by two Phillips screws and the stock is held on by one bolt. Remove the pad by unscrewing the Phillips screws and remove the stock bolt to free the stock from the shotgun.(Fig. 1) Remove any metal spacers that remain.
Step 2: Attach the BreachersGrip to the shotgun by aligning the pistol grip with the rear of the shotgun receiver. (Refer to Fig. 2) Using the appropriate Hex wrench, tighten the pre-installed Hex head bolt firmly to complete the installation.
 WARNING: During recoil, the shotgun moves rearward over the pistol grip by slightly more than one inch. Do not place any body parts close to the rear of the pistol grip. Keep face and other body parts at least 2 inches from rear of receiver extension.
|
|
|
