IInstallation Instructions | Product Maintenance & Important Info | Product Service Info | Download Owners Manual
Installation Part 1 | Installation Part 2 | Installation Part 3 | Installation Part 4
Proper alignment with scopes or raised sights requires the use of the included cheek rest accessory.
1. Determine the correct height cheek rest. Note: The cheek rest is packaged as two separate pieces: Part A, "Lower" cheek rest used for raised rifle sights or low mounted scopes; Part B, "High" cheek rest used for raised scopes (Most commonly used).
IMPORTANT NOTICE: Once installed the Cheek Rest is difficult to remove. Please plan your desired Cheek Rest configuration carefully.
2. If the desired configuration involves the use of the high cheek piece proceed with this step. If the desired configuration involves only the use of the low cheek piece proceed to Step 3. Utilizing the high cheek piece requires the use of the low cheek piece. With the two long flat edges facing down, place the low cheek piece on a level work surface. Take the high cheek piece in one hand while holding the low cheek piece in a steady position. Slide the high cheek piece down over the top of the low cheek piece. (Fig. 1) Note: Imprinted "Power Pak" logo on the high cheek piece should align with the logo on the low cheek piece. The high cheek piece should lock down and completely cover the low cheek piece. The rear portion of the high cheek piece should be flush with the rear portion of the low cheek piece.
Fig. 1
3. To complete Cheek Rest installation, remove the rear portion of the Axiom Rifle Stock. With the butt pad facing down, place the rear portion of the stock on a flat work surface. Take the assembled Cheek Rest with the rear of the Cheek Rest assembly facing down and slide down over the rear portion of the stock. with both hands, push firmly down until rear of Cheek Rest assembly is aligned with the front of the rubber butt pad. (Fig. 2) Note: The angled “gripping teeth” on the inside of the Low Cheek Piece should be positioned with angle facing the work surface.
Fig. 2
4. Reinstall the rear portion of stock back onto Axiom Rifle Stock (Fig. 3)
Fig 3
|
