IInstallation Instructions | Product Maintenance & Important Info | Product Service Info | Download Owners Manual
Installation Part 1 | Installation Part 2 | Installation Part 3 | Installation Part 4
4. Carefully insert receiver or barreled action into the forend. Carefully align recoil lug and trigger with corresponding pockets or openings. Slowly lower barreled action into forend until it is fully seated. (Fig. 4) Note: The barreled action should slide into position with limited hand pressure and when in final position there should very minimal movement.
5. While holding the assembly from Step 4, reinstall the magazine housing into the corresponding pocket on the bottom of the receiver. (Fig. 5) Note: To avoid damage to the hinged floor plate and trigger guard in the following steps, the magazine housing must be correctly installed in the receiver. Verify that the magazine housing is properly installed.
6. Reinstall trigger guard and hinged magazine floor plate assembly. (Fig. 6) Note: It is crucial that the trigger guard and hinged magazine floor plate assembly is properly seated in the stock prior to final installation and torquing of bolts.
7. While holding the trigger guard and hinged magazine floor plate assembly in position, reinstall the two stock bolts removed in Step 1. (Fig. 7) Note: Take extra precaution not to cross thread bolts. For best performance, utilize a torque wrench and tighten bolts to a recommended torque of 65 inch lbs. Floor plate should open and close easily.
|
