|
|
IInstallation Instructions | Product Maintenance & Important Info | Product Service Info | Download Owners Manual
Installation Part 1 | Installation Part 2 | Installation Part 3 | Installation Part 4
1. Remove action bolt from receiver. Remove original stock. Refer to manufacturer’s instructions for the best method to remove stock. Normally the barreled action is held in position by two screws located on the bottom of the stock. Using caution not to damage screws, use the appropriate size and type of tool to remove the two screws (Fig. 1A). Note: At this point the trigger guard is disconnected from the stock. For BDL models remove bottom magazine floor plate along with magazine housing. (Fig. 1B on the following page) Remove barreled action from stock. To avoid damage, take caution when removing barreled action from original stock.
 
2. Prepare Axiom V/S Rifle Stock for Installation by removing rear butt stock. To remove pull down on lever assembly and slide off buttstock. (Fig. 2)
3. Installation of the Axiom V/S Rifle Stock also requires the removal of the pistol grip portion of the stock. The stock is attached to the forend with a preinstalled bolt and lock washer. To loosen bolt, insert the provided ¼” ball end allen wrench into the hole located on the bottom of the stock. Turn wrench counter clockwise until stock is free from forend. (Fig. 3)
|
|
|
|
|
